Для заказов Green Pin: тел.8-800-707-06-93 (беспл. по РФ)

61 Wire Rope Clips 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 The second clip must be placed immediately against the thimble but nevertheless in such a position that the correct tightening of the clip does not damage the outer wires of the wire rope (figure 2). Tighten the nuts firmly but not yet to the specified torque. The following clips should be placed on the wire rope between the first and second clip in such a way that they are separated by at least 1½ times the clip-width with a maximum of 3 times the clip-width, according to figure 3. Apply light tension on the rope and tighten all nuts evenly, alternating until reaching the specified torque. During assembly and before the rope is taken into service, the nuts must be tightened once again to the prescribed torque. After the load is applied for the first time, the torque value must be checked again and cor- rected if necessary. Periodically re-tightening of the nuts must be done at 10.000 cycles (heavy usage), 20.000 cycles (moderate usage) or 50.000 cycles (light usage). If cycles are unknown, a fixed time period could be used, e.g. every 3 months, 6 months, annually. The torque values and the minimum number of clips to be applied, in relation to the rope size, are given in the following tables. diameter diameter min. no length of rope torque torque wire wire of clips to turn back value value rope rope required inch mm mm Nm Ft.Lbs 1 / 8  3 - 4  2   85 6.1 4.5 3 / 16  5  2   95 10.2 7.5 1 / 4  6 - 7  2  120 20.3 15 5 / 16  8  3  133 40.7 30 3 / 8  9 - 10  3  165 61 45 7 / 16 11 - 12  3  178 88 65 1 / 2 13  3  292 88 65 9 / 16 14 - 15  3  305 129 95 5 / 8 16  3  305 129 95 3 / 4 18 - 20  4  460 176 130 7 / 8 22  4  480 305 225 1 24 - 25  5  660 305 225 1 1 / 8 28 - 30  6  860 305 225 1 1 / 4 32 - 34  7 1120 488 360 1 3 / 8 36  7 1120 488 360 1 1 / 2 38 - 40  8 1370 488 360 1 5 / 8 41 - 42  8 1470 583 430 1 3 / 4 44 - 46  8 1550 800 590 2 48 - 52  8 1800 1017 750 2 1 / 4 56 - 58  8 1850 1017 750 2 1 / 2 62 - 65  9 2130 1017 750 2 3 / 4 68 - 72 10 2540 1017 750 3 75 - 78 10 2690 1627 1200 Table 1, Green Pin ® wire rope clips generally to EN 13411-5 Type B, required number and torque value Figure 2 Figure 3