Для заказов Green Pin: тел.8-800-707-06-93 (беспл. по РФ)

60 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 Wire Rope Clips Wire rope clips are used on wire rope eye-loop connections or complete loops, end-to-end connections where socketing or splicing is not feasible or when a temporary joint is required. Applications Van Beest offers a wide range of wire rope clips, specifically standardized models such as EN13411-5, US Federal Specification wire rope clips and DIN wire rope clips. Range The Green Pin ® wire rope clips are drop forged and have a bridge with grooves to fasten the wire rope properly in the clip; the DIN wire rope clips have a malleable base, without grooves. Design The finish is either electro-galvanized or hot dipped galvanized, unless otherwise specified. Finish Upon request, all wire rope clips can be supplied with a works certificate. Certification Wire rope clips should be inspected before use to ensure that: • all markings are legible; • the wire rope clip is free from nicks, gouges and cracks; • a wire rope clip with the correct dimension has been selected; • never repair or reshape a wire rope clip by welding, heating or bending as this may affect the performance. The wire rope clip should be fitted to the wire rope as shown in the figures. The bridge of the wire rope clip should always be placed on the load bearing part of the rope. The U-bolt of the clip should be placed on the rope tail, also known as the dead end of the rope. Turn back enough wire rope length so that the required minimum number of clips can be installed according to the instructions below. The first clip must be placed one bridge width from the turned back rope tail or dead end of the rope, according to figure 1. Tighten the nuts to the specified torque. Instructions for use Figure 1