Для заказов Green Pin: тел.8-800-707-06-93 (беспл. по РФ)

13 Shackles 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 Certification Upon request at time of order, all load rated shackles can be supplied with any of the following documents or certificates: - works certificate in accordance with EN 10204 - 2.1 or 2.2; - material certificate in accordance with EN 10204 - 3.1; - manufacturer test certificate; - EC Declaration of Conformity in accordance with annex IIA of the machine directive 2006/42/EC; - inspection certificate in accordance with EN 10204 - 3.2; - proof load test certificate; - certificate with the actual breaking load experienced on tested samples; - test report of Magnetic Particle Inspection (M.P.I.); - test report of Ultrasonic Inspection (U.S.). The first four of the above mentioned certificates can be supplied at no extra charge. For all other certificates, additional costs will be charged. The test certificates can be supplied surveyed by all official classification societies, such as Lloyd’s, Det Norske Veritas, British Standards Bureau, American Bureau of Shipping, Germanischer Lloyd’s or any other officially certified inspection body. Green Pin ® Standard Shackles and Green Pin ® Polar Shackles are DNV type approved to certification Note 2.7-1, lifting sets for offshore containers. Instructions for use Shackles should be inspected before use to ensure that: • all markings are legible; • the body and pin are both identifiable as being of the same size, type and make; • the threads of the pin and the body are undamaged; • never use a safety bolt type shackle without using a securing pin; • the body and the pin are not distorted or unduly worn; • the body and pin are free from nicks, gouges, cracks and corrosion; • shackles may not be heat treated as this may affect their Working Load Limit; • never modify, repair or reshape a shackle by welding, heating or bending as this will affect the Working Load Limit. Assembly Ensure that the pin is correctly screwed into the shackle eye, i.e. tighten hand-tight, then secure using a wrench or other suitable tool so that the collar of the pin is fully seated on the shackle eye. Ensure that the pin is of the correct length so that it penetrates the full depth of the screwed eye and allows the collar of the pin to seat on the surface of the shackle eye. Incorrect seating of the pin may be due to a bent pin, too tight fitting thread or misalignment of the pin holes. Do not use the shackle under these circumstances. Never replace a shackle pin except with one of the same size, type and make as it may not be suitable for the loads imposed. Select the correct type of shackle and its Working Load Limit for the particular application. Should extreme circumstances or shock loading be applicable, this must be well taken into account on selecting the correct shackle. Please note that commercial shackles are not to be used for lifting applications. Make sure that the shackle is supporting the load correctly, i.e. along the axis of the shackle body centreline, avoid introduction of bending loads, unstable loads and do not apply overloads.