Racor: Морские фильтрационные системы и решения

35 Racor Water Detection Kits are available in a wide selection for various installation requirements. Under-dash, in- dash, and remote mount, these solid-state units may be used with any Racor fuel filter/water separator and water probe. They are manufactured using the highest quality materials and are all 100% electrically tested. An electronic detection module analyzes electrical resistance at the water probe and determines if water is present. If so, the detection module operates to indicate water, based on its features listed below. All units reset automatically after water is removed (unless specified). Caution: The water probe and detection modules work with 12 or 24 volts, direct current only and should never be wired to other brand modules or household 110 or 220 volts, alternating current. Use the guide below to find the correct detection module for your application. Part Number Description Voltage Image RK 12870 Under-dash water detection module. Light illuminates and alarm sounds when water is detected. Water must be drained to reset light and stop alarm. Plastic enclosure measures: 1.38” square x 1.25” deep. Water probe included. 12 vdc RK 12871 Same as above 24 vdc RK 20725 Under-dash mount water detection module. Light only. Green ‘ON’ lamp illuminates with power on. Red ‘DRAIN’ lamp illuminates when water is detected. Initial power-up self diagnosis feature and circuit protection included. Plastic enclosure measures: 2.75” x 1” x 1.5”. Water probe included. 12 vdc RK 20725-24 Same as above 24 vdc RK 20726 2” gauge-type water detection module. Light and audio. Red ‘DRAIN’ lamp illuminates and horn sounds when water is detected. Initial power-up self diagnosis feature and circuit protection included. Plastic case, satin black dial with white lettering. Water probe included. 12 or 24 vdc RK 11-1570 1 2” gauge-type water detector and filter restriction module. Includes pre-set vacuum switch (7 inHg), connector, and outlet adapter fitting. Red ‘DRAIN’ or ‘CHANGE FILTER’ lamp illuminate and horn sounds when water is detected. Water probe included. 12 or 24 vdc RK 14329 Remote detection unit sends 12 VDC hot (+) signal when an input ground signal (from a water probe or a vacuum switch—not included) is received. Must be used with a relay to power a horn or indicator lamp (if draw is over 1 amp). Plastic enclosure measures: 3” x 2.5” x .75” 12 vdc RK 14321 Same as above 24 vdc 14332 Under-dash mounts same as RK 14329 but sends a ground (–) signal. Enclosure size is same as RK 20725 above. 12 vdc RK 20163 Vacuum Switch Kit Non-adjustable, ‘Normally Open’ contacts close at 7 inHg (3.4 PSI) 1/8"-27 NPT threads. For use with all models. N/A RK 21030 Vacuum Switch Connector Kit Molded connector with single 18 AWG., 18" blue wire lead. N/A RK30880E This kit includes new and enhanced detection electronics built into the probe body and works with 12 or 24 volt DC systems. Water probe and detection module all in one. 12 or 24 vdc Clear collection bowl must have a 7/8” SAE port. Water Detection Modules & Kits