Для заказов: тел.8-800-707-06-93 (беспл. по РФ)

Safety in action 5 Star Alloy KWB Star Alloy G 100 – Characteristics Permissible working temperature: Bending acc. to PAS 1061/EN 818-2: Breaking elongation: Breaking stress: 1.000 N/mm² – corresponds to 4 times the load capacity Test stress: 625 N/mm² – corresponds to 2,5 times the load capacity Stress at load capacity limit: 250 N/mm² Chain quality: 0,8 x nominal diameter min. 20% Surface: Violet powder coated Purple varnished The performance concerning stress crack corrosion is identical to Grade 80. Working Load Tag: All the required data is shown on the working load tag. For simple identification and to avoid mistakes with the chain qualities, different tags are used. Asymmetric load distribution b b b R R Angle of inclination Load factor up to 45° 0,7 45°–60° 1 up to 45° 0,7 45°–60° 1 up to 45° 0,5 45°–60° 0,7 Impact load Load factor slight impact 1 medium impact 0,7 strong impact impermissible Edge loads Load factor R = larger than 2x chain-Ø R = larger than chain-Ø R = chain-Ø or smaller 1 0,7 0,5 Temperature -40° to 200°C 1 1 above 200° to 300° C impermissible 0,9 above 300° to 380° C impermissible 0,75 Load factor Star Alloy R Corresponds with ASTM 973/A973M-01 & EN 818-2 but with higher working load limit (permissible operating temperature max. 200°C) & machinery directive 98/37/EC Note: Working Load tags should only be assembled acc. EN 818-4 and by competent persons. KWB has two working load tags, for Star Alloy and Star Alloy Plus. The shape helps to identify the grade (load capacity) and possible application (temperature). Working load tags can be used solely when the particular chain & KWB components are assembled in the chain sling. Should alternative working load limits arise in the chain sling through the use of special parts, the tags are impermissible. Disregard of these instructions can lead to material damage and personal injury. KWB will not assume liability. max. 380°C max. 200°C Corresponds with PAS 1061 Corresponds with EN 818-2 with a higher load capacity & machinery directive 98/37/EC Components max. 380°C max. 380°C Grade marking: 10 (some components are still marked with 8S) 10 at a spacing of approx. 300 mm up to dim. 16 (others 900 mm) and 10 on the back of each link 8S at a spacing of approx. 300 mm up to dim. 16 (others 900 mm) Components 10 at a spacing of approx. 300 mm Components Violet varnished Violet varnished Star Alloy Star Alloy Plus PAS/Star Alloy Plus+ Star Alloy Plus+/PAS Star Alloy Star Alloy Plus PAS Star Alloy Plus+ SA/S SAPP/S SAP/S Star Alloy SA/S Star Alloy Plus+ SAP/S Star Alloy Plus PAS SAPP/S Star Alloy SA/S Star Alloy Plus PAS SAPP/S Star Alloy Plus+ SAP/S Star Alloy SA/S Star Alloy Plus PAS SAPP/S Star Alloy Plus+ SAP/S